Victron VE.Can to CAN-bus 5m BMS-kabel type A

 22,00 incl. BTW

Artikelnummer: ASS030710050 Categorie:

Beschrijving

Victron VE.Can to CAN-bus 5m BMS-kabel type A

Use these VE.Can to CAN-bus cables to connect a CAN-bus enabled battery to a GX device.

1. Selecting the right cable

ASS030710050 – VE.Can to CAN-bus BMS type A Cable 5m

  • BYD B-Box
  • Pylontech US2000C/US3000C/UP5000/Force-L

ASS030720050 – VE.Can to CAN-bus BMS type B Cable 5m

  • LG Chem Resu
  • AXIstorage
  • BMZ
  • Pylontech US2000/US3000/UP2500
  • Solar MD BMS EX

2. Installation

The side labeled ‘CAN-bus BMS’ plugs into the battery. The other side, labeled ‘VE.Can’ must be plugged into either the VE.Can port of the GX device, or the BMS-Can port.

Both port types (VE.Can and BMS-Can) on a GX Device can be configured for use with a CAN-bus BMS connected third party battery.

For configuration, see the manual specific to the brand of battery you are using.

3. Pin-out

In some cases it might be needed to make the cable at the location. Find below the pin-outs. Make sure to very carefully test the cable after crimping it. Self-made cables are very often the causes of very hard to diagnose problems.

3.1 Type A

FunctionVictron VE.Can sideBattery side
GNDPin 3Pin 6
CAN-LPin 8Pin 5
CAN-HPin 7Pin 4

3.2 Type B

FunctionVictron VE.Can sideBattery side
GNDPin 3Pin 2
CAN-LPin 8Pin 5
CAN-HPin 7Pin 4

Beoordelingen

Er zijn nog geen beoordelingen.

Wees de eerste om “Victron VE.Can to CAN-bus 5m BMS-kabel type A” te beoordelen

Het e-mailadres wordt niet gepubliceerd. Vereiste velden zijn gemarkeerd met *